聯系人:安經理
手機:152-5313-4653
郵箱:347299818@qq.com
地址:濟南市濟北開發區
1、飼料混合機http://m.ywkjw.com/長期作業,應固定在水泥基礎上,飼料混合機安裝完后要檢查各部緊固件的緊固情況,若有松動須予以擰緊。
Mixer long-term operation, should be fixed on the basis of cement, feed mixer after installation to check ministries fastening fasteners, if loose must be tightened.
2、要檢查飼料混合機皮帶松緊度是否合適,電動機軸和粉碎機軸是否平行,飼料混合機的粉碎機啟動前,先用手轉動轉子,檢查一下齒爪、錘片及轉子運轉是否靈活可靠,殼內有無碰撞現象,轉子的旋向是否與機上箭頭所指方向一致,電機與粉粹機潤滑是否良好。
To check the feed mixer belt tension is appropriate, the motor shaft and the shaft is parallel to the mill, feed mixer grinder before launch, the first rotation of the rotor by hand, check the tooth claw hammer and rotor operation is flexible, reliable, shell whether the collision phenomenon within the rotor rotation is consistent with the direction of the arrow on the machine, motor and splintered machine lubrication is good.
3、不要隨便更換飼料混合機的皮帶輪,以防轉速過高使粉碎室產生爆炸,或轉速太低影響工作效率,飼料混合機啟動后先空轉2-3分鐘,沒有異常現象后再投料工作。
Do not replace the feed mixer pulley, so speed is too high to prevent the crushing chamber to produce an explosion, or the speed is too low affects the efficiency of the first idle feed mixer for 2-3 minutes after start, no anomalies before feeding work.
4、飼料混合機http://m.ywkjw.com/操作人員不要戴手套,送料時應站在粉碎機側面,以防反彈雜物打傷面部,飼料混合機堵塞時,嚴禁用手、木棍強行喂入或拖出飼料。
Mixer operators do not wear gloves, should feed mill stood side, to prevent debris rebound wounded face, feed mixer when blocked, prohibited by hand, sticks to force feed or out of feed.